8X FD4616 Fuel Filter (for 6.0L)& FL2016 Oil Filter For 2003-2007 Ford Excursion
Replaces part number:3C3Z9N184CB, 3C349N074BA, FD4604, FD4616,3C3Z9N184CA. Function:Help block impurities and contaminants in your fuel before they can enter your engine, improve performance by ensuring a uniform fuel flow. SUPERIOR FILTRATION MEDIA:Optimally screening out 98% of abrasives such as carbon, sand, dust and bits of metal before they get into your oil. Package Includes:8 Packs (1 Pack includes a set of FD4616 fuel filter and a set of FL2016 oil filter), please check it.
6.0L Powerstroke Turbo Diesel Fuel Filter for V8 engines. NOT NOT FIT 2006 E450 6.0L. The primary fuel filter is located in the Horizontal Fuel Conditioning Module, mounted to the driver side frame rail. The Horizontal Fuel Conditioning Module also contains the water-fuel separator.
The secondary filter is positioned on the top side of the engine, just right of the engine oil filter. Recommends replaces both fuel filters at 15,000 mile intervals under "normal" service conditions and 10,000 mile intervals under "severe" service conditions. The primary fuel filter install. Remove the drain plug uses a 6 mm Allen wrench for the water-fuel separator and drain the fuel into a container. Allow the Horizontal Fuel Conditioning Module to drain completely, then fish out the drain plug and dispose of the fuel. Remove the primary fuel filter cap with a 36 mm socket. Remove the fuel filter from the cap by simply pulling it out. There is a retaining clasp on the fuel filter that snaps into the fuel filter cap.Remove and replace the o-ring from the fuel filter cap. Install the new fuel filter, minding the orientation of the locking clasp and the o-ring. The o-ring side of the fuel filter is not inserted into the cap. The fuel filter should lock into the cap.
Lightly coat both o-rings (cap and bottom of filter) of the new fuel filter with clean motor oil before installing into the Horizontal Fuel Conditioning Module. Torque cap to 19 lb-ft (25 N-m). Reinstall the fuel-water separator drain plug. The secondary fuel filter install. Remove the cap with either a 24 mm socket or 1/2 inch square drive.
Remove and discard the used fuel filter. Drain the fuel filter housing of any fuel. Install the new fuel filter into the fuel filter housing.Remove and replace the o-ring on the fuel filter cap. Lightly coat the o-ring with clean motor oil, then reinstall the cap.
Torque to 10 lb-ft (14 N-m); do not overtighten the cap. Turn the key into the "run" position (as you would to initiate the glow plug sequence) for 30 seconds, then back to the "off" position. Repeat this procedure a minimum of 3 times in order to prime the fuel system before starting. The item "8X FD4616 Fuel Filter (for 6.0L)& FL2016 Oil Filter For 2003-2007 Ford Excursion" is in sale since Friday, August 6, 2021.
This item is in the category "eBay Motors\Parts & Accessories\Car & Truck Parts\Filters\Fuel Filters". The seller is "gef_7637" and is located in Walton, Kentucky. This item can be shipped to United States.
- Brand: gef_7637
- Manufacturer Part Number: FD4616 FL2016
- Fuel Type: Diesel
- Filter For: Water
- Fitment Type: Direct Replacement
- Warranty: 60 Day
- Interchange Part Number: Fits Motorcraft FD4616
- Other Part Number: FD4616, FD4604, 3C3Z9N184CA
- Country/Region of Manufacture: China
- Placement on Vehicle: Front
- Bundle Listing: Yes